This feature is not intended for UL installations. Refer to the RF User Guide for this procedure. The RF must be at least 10 feet from the control panel to ensure proper operation of the RF receiver. Perform the following steps to install the RF. Push the two case release snaps at the bottom of the keypad with the blade of a medium screwdriver this will push in the release snap , then pull that side of the case back away. Insert the screwdriver in the side of the keypad between the front and back case and gently twist to release the side locking tab.
|Published (Last):||25 October 2008|
|PDF File Size:||5.14 Mb|
|ePub File Size:||19.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
Below is a chart showing these values. Regardless of which wireless key you use even if it is one not shown , loops are defaulted for all 8 devices as shown. These values may be changed to suit the installation. Page 4 Defaulting the RF To restore the RF to the default values, perform the following steps: Step Action Enter the Program mode by pressing the  and  keys simultaneously for a few seconds within 30 seconds after applying power.
Press the  key. Enter  to enable, or  to disable. Note: Make sure the number of receivers set for Enable 1 does not exceed the capacity of the control panel. Enter the loop number Flashes "Ln. Perform steps 6 through 10 only if it is necessary entered, alternately flashes to change any of the loop functions. Page 7: Specifications Deleting, Replacing, or Editing Wireless Keys Use the following procedure to delete, replace, or change any of the programming for a wireless key.
Step Action Display Enter the Program mode by pressing the  and  keys Alternately flashes "oo" and simultaneously for a few seconds within 30 seconds after applying two dashes. This manual is also suitable for: Ademco Ademco mDemco tm.
Honeywell 6150RF (K4392V2-H M7240) Owners Manual
Honeywell ADEMCO 6150RF PDF manual
Honeywell ADEMCO 6150RF Installation And Setup Manual